XC 7.0MM Volcano How to

1. Prepare the Nail – Ensure the nail is clean and dry before using the drill bit.
2. Set the drill speed – Use at 25000 – 30000 RPM for removing thick layers of acrylic or hard gel.
3. Hold the Drill Steady – Hold firmly with both hand if needed, since the volcano bit is designed for aggressive removal.
4. Use Gentle pressure – The extra-coarse grooves on this bit allow it to remove product with minimal force.
5. Move in both directions – Move forward and backward to remove product evenly, especially effective on thick overlays.
6. Clean and Finish up – Dust off the nail and disinfect the bit after each use.